Note: If all of the Mode LEDs begin to blink after you have held the Mode button for 2 seconds or you cannot get the four LEDs to remain lit, a configuration already exists on the switch. When the four LEDs turn green, release the Mode button. Note: This only works on switches that do not have a configuration file in their file system.ģ. Press and hold the Mode button, as shown in Figure 1, until the four LEDs next to the Mode button turn green.
Verify that no devices are connected to the switch.Ģ. Save this configuration to nvram and exit.Follow these steps to start the Express Setup program.ġ. Return back to the setup without saving this config. Go to the IOS command prompt without saving this config. Subnet mask for this interface :255.255.255.0 NOTE: this is the IP we are going to use to connect to this switch using our broswer for the web interface Management network from the above interface summary: FastEthernet0/24 (Or set whatever Interface you want)Ĭonfigure IP on this interface? : yes
Configure a cisco 2950 switch password#
The virtual terminal password is used to protectĪccess to the router over a network interface.Įnter virtual terminal password(enter whatever you want your password to be)Įnter interface name used to connect to the
Configure a cisco 2950 switch software#
The enable password is used when you do not specify anĮnable secret password, with some older software versions, andĮnter enable password(enter whatever you want your enable password to be)
This password, afterĮntered, becomes encrypted in the configuration.Įnter enable secret : (enter whatever you want your secret password to be) The enable secret is a password used to protect access to Would you like to enter basic management setup? : noįirst, would you like to see the current interface summary? : noĮnter host name (enter whatever you want to name your switch) Now you are back to the promp and enter this command:Ĭontinue with configuration dialog? : no
Now that the flash OIS has been initialized, select 'boot' from the main and hit enter on your keyboard, the switch will start to load the OS until you get to a message that says: Press RETURN to get started! Parameter Block Filesystem (pb:) installed, fsid: 4 Now the setting has been set to factory defaults:įlashfs: 0 orphaned files, 0 orphaned directoriesīoot Sector Filesystem (bs:) installed, fsid: 3 The flash filesystem, and finish loading the operatingĮnter: flash_init and hit Return on your keyboardĪfter you select flash_init you will see a message: Initializing Flash. The system has been interrupted prior to initializing theįlash filesystem. Ok now that we have connected to the switch using hyperterminal and you are at the main flash menu: you should see something that looks like this:Ġ0:00:17: %SYS-5-CONFIG_I: Configured from memory by consoleĠ0:00:17: %SYS-5-RESTART: System restarted -Ĭisco Internetwork Operating System Software
0 kommentar(er)
